6 3/4” Aperture Incandescent Standard Frame-In Kit

1. Mounting Frame: .036" (#20 ga.) galvanized steel.Accommodates all ceilings up to 1” thick;
   including existing or inaccessible areas. Four slots positioned 90° apart to simplify alignment,
   breakout section and anchor nails permit installation in existing ceilings from below.
   Push-in/twist-out rotoclips hold reflector flush to ceiling.
2. Junction Box: 4” x 3 1/2 x 2”: .063 (#14 ga.) galvanized steel. U. L. listed for maximum of 8 No. 12 ga. 75° C
   through branch circuit conductors (60° C end of run). Integral cable clamps permit attachment of
   nonmetallic Romex® or armored cable without need of additional connectors.
3. Mounting Bars: .059” (#16 ga.) galvanized steel. 13” long bars extend to 27”,
   rotatable and lockable, with integral T-bar tabs.
   Attach to wood joist or T-bar ceilings without need of accessories.
4. Socket Housing: Impact extruded aluminum or galvanized steel.
5. Socket: Porcelain medium base; nickel plated screw shell.
   Pre-wired with #18 ga. SF1 leads to junction box.
6. Thermal Protector: Meets NEC and UL requirements.
   Insulation must be kept 3” away from fixture sides and wiring compartments
   and must not be placed above fixture in a manner which will entrap heat.