Lytening Shallow AirSeal Convertible (IC/Non-IC)
6 3/4" Aperture

For restricted plenums or shallow ceiling cavaties with 2" x 6" joist construction.
For use in insulated or non-insulated ceilings.
AirSeal for restricted air leakage, complies with the MEC and WSEC energy codes.

Compatible Trims: B17, B17WH, 1178LX, 1177LX

1. Housing: .032” (#20 ga.) Aluminum. UL listed convertible IC/NON-IC.
   2” vertical adjustment in ceiling. Can be removed for access to junction box and ceiling plenum.
   5 1/2” tall for use in 2” X 6” joist construction and shallow plenum applications.
   AirSeal® housing minimizes air leakage to less than 2 CFM at 1.57 PSF (or 75pa),
   which complies with Model Energy Code (Section 602.3.3) and Washington State Energy Code
   (Section 502.4) and reduces heat loss and condensation in ceiling.
2. Mounting Frame: .048” (#18 ga.) galvanized steel. Locks into position along length
   of mounting bars with locking spring and bendable slot. (3) slots 90° apart simplify alignment.
3. Junction Box: 2” X 4” X 3 1/2” (22 cu. in.) .032” (#22 ga.) galvanized steel.
   UL listed for maximum of 8 (#12 ga.) 1104SIC/N and 6 (#12 ga.) 1004SIC/N 90°C through branch
   circuit conductors. Integral cable clamps permit attachment of non-metallic (#12 or #14 ga.)
   Romex® cable without tools or additional connectors.
4. Mounting Bars: .059” (#16 ga.) galvanized steel. Bars pivot for easy attachment and
   wire-in below ceiling line. Bars extend to accommodate 16” to 24“ O.C. joist spacing.
   Bars can accommodate 9” O.C. joist spacing after a slight field modification (See Instruction Sheet).
   1104SIC features integral self-tapping phillips screws for secure attachment to wood or metal construction.
   The 1104SICN features integral nails for secure attachment to wood.
   Both attach to T-bar ceilings without the need of accessories.
5. Socket Housing: Impact extruded aluminum or galvanized steel.
   Attached trim retaining spring secures trim to any height on housing wall.
6. Socket: Porcelain medium base; nickel plated screw shell.
   Pre-wired with #18 ga. SF1 (300 Volt 200° C) leads to junction box.
7. Thermal Protector: Meets NEC and UL requirements. Located inside housing.